Pool pumps are an essential part of any pool. They help circulate the water and maintain a safe, enjoyable experience for swimmers. However, they do require some upkeep to function correctly.
If you are in charge of maintaining your pool, then you must know how to prime a pump. This will save time and money in the long run. There are many different ways to prime a pump. But this article will go over some tips that have worked for us in the past.
Keep The Skimmer Clean
Keep the skimmer and pump baskets clean. These will trap debris like leaves and dirt, clog your system and make it more difficult for water to circulate throughout the pool. To keep them clear of unwanted materials, remove them about once a week or every time you use your pool. You can save on pump baskets through coupons.
Add salt when necessary! Salt systems are another critical component of the pool, allowing you to sterilize your water so swimmers can enjoy it easily. But for these systems to function appropriately, salt levels need to be at the right amount. It will vary based on how frequently you use your pool and local climate conditions.
Use A Pump Strainer
These are typically included with new pumps or sold separately as an accessory between the skimmer line and pump basket. They’re explicitly designed to reduce blockages by collecting particles while still allowing water through without any trouble.
It is constructive when using the pool who might accidentally drop objects into it like coins or toys. You can check for coupons on the pump strainer for savings.
Drain And Refill
Drain and refill your pool every year! It’s essential to check for leaks, but it is also crucial to maintain the proper water levels. If there are any issues or if chemicals need to be added, the process will help make sure they get into the right places and prevent dirt from collecting on the bottom of your pool.
Clean Skimmer Baskets
Clean out skimmer baskets at least once a week! Similar to pump baskets, these should be completely free of debris to properly function and circulate water through your system. They can exclude small particles like leaves and bugs (which might end up clogging other parts). It means cleaning them regularly should become part of your routine maintenance tasks without fail! You can check for deals on skimmer baskets for savings.
Turn Off The Valves
Make sure all valves are turned off after every use! Pumps are huge energy consumers, so it’s crucial to ensure they’re turned off when not in use. It will lower the amount of time required for priming and save you money on your monthly utility bills- which is always a nice perk.
Add chemicals before turning everything back on! By making this part of your routine maintenance tasks, you can avoid many future issues that could arise from improper water chemistry levels and balance.
No Air In The Plumbing
Ensure no air in the plumbing by checking all connections for leaks and tightening them if they do not appear watertight already. Air trapped inside will cause resistance when the pump tries to run, so always check before priming it again after finding an issue with leaking pipes.
You can determine this by feeling around each connection point while primed or looking at each fitting. Air may also get into some valves too, but these are usually found close together.
Make sure to add a small amount of non-chlorine shock. It will remove any free chlorine that your pool might have while you prime the pump and filter. When it comes out, there may be some cloudiness or even foaming at first, but don’t worry! It should clear up within 24 hours if all goes well with priming and filtering. You can check for discounts on non-chlorine shocks for savings.
Pumps are an integral part of a pool system. They circulate water and filter out debris. If the pump is not working correctly, you will need to prime it before using it again. You can also check for steps to build a concrete pool for further help!